Siemens SINUMERIK 808D Parameter Manual page 453

DB390x
DBX2.2
Edge evaluation: No
Signal state 1
corresponding to ...
Note for the reader
DB390x
DBX2.3
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB390x
DBX2.4
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB390x
DBX2.5
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
Parameter Manual
List Manual, 01/2017
Revolutional feedrate active
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
When programming G95 (revolutional feedrate) in the JOG mode or auto‐
matic mode.
SD41100 JOG_REV_IS_ACTIVE
(revolutional feedrate for JOG active)
SD42600 JOG_FEED_PER_REV_SOURCE
(In the JOG mode revolutional feedrate for geometry axes, on which the
frame with rotation acts)
SD43300 ASSIGN_FEED_PER_REV_SOURCE
(Revolutional feedrate for position axes/spindles)
MD32040 JOG_REV_VELO_RAPID
(Revolutional feedrate for JOG with rapid traverse override)
MD32050 JOG_REV_VELO (revolutional feedrate for JOG)
Function Manual, Expansion Functions P2
Function Manual, Special Functions M3
Measurement active
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
The "Measuring" function is active.
The instantaneous measurement status of the axis is displayed (measuring
set with this axis is running).
The "Measuring" function is not active.
Function Manual, Expansion Functions M5
Activate travel to fixed endstop
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
The "Travel to fixed stop" function is active.
The "Travel to fixed stop" function is not active.
Function Manual Basic Functions F1
Fixed stop reached
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
The fixed stop was reached after selecting the "FXS" function.
The fixed stop has still not been reached after selecting the "FXS" function.
Function Manual Basic Functions F1
Detailed descriptions of interface signals
5.8 Axis / spindle-specific signals
453