M_No_Fct_Stopre; M_No_Fct_Eop; M_No_Fct_Cycle - Siemens SINUMERIK 808D Parameter Manual

Machine data
3.2 General machine data
Subsequent odd address:
The following three types of NC codes can reconfigured:
1. G codes
2. NC addresses
3. Pre-defined subprograms e.g.: CONTPRON, ...
10713

M_NO_FCT_STOPRE

- M function with preprocessing stop
-
- 15
Description:
The M functions defined by MD10713 $MN_M_NO_FCT_STOPRE perform an implicit
preprocessing stop.
That is, the interpretation of the next part program line will be stopped until the
block with the M function defined in that way has been processed completely
(PLC acknowledgment, motion, etc.).
10714

M_NO_FCT_EOP

- M function for spindle active after reset
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
For spindles where a '2' is configured in MD35040 $MA_SPIND_ACTIVE_AFTER_RESET, no
spindle reset is enabled with this M function when the part program is terminated. The
spindle therefore remains active after the end of the part program.
Proposal: M32
Restrictions: see MD10715 $MN_M_NO_FCT_CYCLE
Related to:
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET
MD10714 $MN_M_NO_FCT_EOP,
MD10715 $MN_M_NO_FCT_CYCLE,
MD20094 $MC_SPIND_RIGID_TAPPING_M_NR,
MD22254 $MC_AUXFU_ASSOC_M0_VALUE
MD10814 $MN_EXTERN_M_NO_MAC_CYCLE,
MD20095 $MC_EXTERN_RIGID_TAPPING_M_NR
10715

M_NO_FCT_CYCLE

- M function to be replaced by a subroutine
-
- 30
Description:
M number with which a subprogram is called.
46
New identifier
e.g.: G02, G64, ASPLINE...
e.g.: RND, CHF, ...
-1, -1, -1, -1, -1, -1, -1, -
-1...
32 -
32 -
32 -
32 -
-1 -
-1 -
-1, -1, -1, -1, -1, -1, -1, -
-1...
EXP, N12, N07 H2
DWORD PowerOn
- 2/2
EXP, N07 K1, H2
DWORD PowerOn
- 1/1
- 1/1
- 1/1
- 1/1
- 2/2
- 2/2
EXP, N12, N07 H2, K1
DWORD PowerOn
- 2/2
M
M
M
M
M
M
M
M
Parameter Manual
List Manual, 01/2017