Siemens SINUMERIK 808D Parameter Manual page 416

Detailed descriptions of interface signals
5.7 Channel-specific signals
DB3300
DBX3.0
Edge evaluation: No
Signal state 1
Signal state 0
Special cases, er‐
rors, ...
Note for the reader
DB3300
DBX3.1
Edge evaluation: No
Signal state 1
Signal state 0
Corresponding to ...
Note for the reader
DB3300
DBX3.2
Edge evaluation: No
Signal state 1
Signal state 0
Corresponding to ...
Note for the reader
DB3300
DBX3.3
Edge evaluation: No
416
Program status running
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The part program was started with IS "NC start" and is running.
● Program stopped by M0/M1 or NC stop or mode change.
● For single block mode, the block is executed.
● End of program reached (M2)
● Program aborted due to a reset
● The actual block cannot be executed
The IS "Program status running" does not change to 0 if workpiece machining
is stopped due to the following events:
● A feedrate disable or spindle disable was output
● IS "Read-in disable"
● Feedrate override to 0%
● The spindle and axis monitoring functions respond
Function Manual Basic Functions K1
Program status wait
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The running program has come to a program command WAIT_M or WAIT_E
in an NC block. The wait condition specified in the WAIT command for the
channel or channels has not yet been fulfilled.
Program status wait is not active.
/PG/ Programming Manual, Fundamentals
Program status stopped
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The NC part program has been stopped by an "NC stop", "NC stop axes plus
spindles", "NC stop at the block limit", programmed M0 or M1 or single block
mode.
Program status "stopped" is not present.
IS "NC stop"
IS "NC stop axes plus spindles"
IS "NC stop at block limit"
Function Manual Basic Functions K1
Program status interrupted
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
Parameter Manual
List Manual, 01/2017