Siemens SINUMERIK 808D Parameter Manual page 367

Description:
The working area defined in the basic coordinate system in the positive direction of
the axis concerned can be limited with axial working area limitation.
The setting data can be changed on the operator panel in the operating area
"Parameters".
The positive working area limitation can be changed in the program with G26.
SD irrelevant for ......
G code: WALIMOF
Related to ....
43430 WORKAREA_LIMIT_MINUS
mm, degrees Working area limitation minus
-
- -
Description:
The working area defined in the basic coordinate system in the negative direction of
the axis concerned can be limited with axial working area limitation.
The setting data can be changed on the operator panel in the operating area
"Parameters".
The negative working area limitation can be changed in the program with G25.
SD irrelevant for ......
G code: WALIMOF
Related to ....
43700 OSCILL_REVERSE_POS1
mm, degrees Oscillation reversal point 1
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Position of the oscillating axis at reversal point 1.
Note:
MD10710 $MN_PROG_SD_RESET_SAVE_TAB can be be set so that the value written by the part
program is transferred to the active file system on reset (that is the value is
retained after RESET.)
Application example(s)
NC language:
Related to ....
Parameter Manual
List Manual, 01/2017
SD43400 $SA_WORKAREA_PLUS_ENABLE
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
-1.0e+8
SD43410 $SA_WORKAREA_MINUS_ENABLE
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
0.0
0.0
0.0
0.0
0.0
0.0
OSP1[Axis]=Position
SD43710 $SA_OSCILL_REVERSE_POS2
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
-
DOUBLE
- -
-
DOUBLE
- -
- -
- -
- -
- -
- -
NC setting data
A3
Immediately
7/7 U
P5
Immediately
7/7 U
7/7 U
0/0 S
0/0 S
7/7 U
7/7 U
367