Siemens SINUMERIK 808D Parameter Manual page 444

Detailed descriptions of interface signals
5.8 Axis / spindle-specific signals
DB380x
DBX2002.7 and .6
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal irrelevant for ...
Application
Special cases, errors, ... ● If both IS are set simultaneously, no oscillation speed is output.
corresponding to ...
Note for the reader
DB380x
DBB2003
Edge evaluation: No
444
Setpoint direction of rotation, counter-clockwise and clockwise
Signal(s) to axis / spindle (PLC → NCK)
Signal(s) updated: Cyclic
If the IS "Oscillation via the PLC" is set, then the direction of rotation for the
oscillation speed can be specified using the two IS "Setpoint direction of
rotation counter-clockwise and clockwise". The times for the oscillation
movement of the spindle motor are defined by setting the IS "Setpoint direc‐
tion of rotation counter-clockwise and clockwise" for a corresponding length
of time.
... spindle modes other than the oscillation mode
see IS "Oscillation via PLC"
● If no IS is set, then an oscillation speed is not output.
IS "Oscillation via the PLC" (DB380x DBX2002.4)
IS "Oscillation speed" (DB380x DBX2002.5)
Function Manual Basic Functions S1
Spindle override
Signal(s) to spindle (PLC → NCK)
Signal(s) updated: Cyclic
Parameter Manual
List Manual, 01/2017