Nc Setting Data - Siemens SINUMERIK 808D Parameter Manual

NC setting data

You can call the help information for the setting data on the PPU by proceeding through the
following steps:
41010 JOG_VAR_INCR_SIZE
- Size of the variable increment for JOG
-
- -
Description:
This setting data defines the number of increments when variable increment (INCvar) is
selected. This increment size is traversed by the axis in JOG mode each time the
traverse key is pressed or the handwheel is turned one detent position and variable
increment is selected (PLC interface signal "Active machine function: INC variable"
for machine or geometry axes is set to 1). The defined increment size also applies to
DRF.
Note:
Please note that the increment size is active for incremental jogging and handwheel
jogging. So, if a large increment value is entered and the handwheel is turned, the
axis might cover a large distance (depends on setting in MD31090 $MA_JOG_INCR_WEIGHT).
SD irrelevant to ......
JOG continuous
Related to ....
NC/PLC interface signal DB3300 DBX1001.5,1005.5,1009.5 (Geometry axis 1-3 active
machine function: INC variable) or NC/PLC interface signal DB390x DBX5.5 (Active
machine function: INC variable)
MD31090 $MA_JOG_INCR_WEIGHT (weighting of an increment for INC/handwheel)
Parameter Manual
List Manual, 01/2017
+ 1. Select the system data operating area.
2. Press this softkey to open the machine data window.
3. Open the target setting data list and select the desired data using the
cursor keys.
4. Press this key to call the help information for the selected data.
Note: You can further press this softkey in the current help screen to
show a complete list of all NC setting data. In addition, you can also
use the following softkey to search for a specific SD by number in this
list:
5. Pressing this softkey exits the help system.
0.
-
DOUBLE
- -
4
H1
Immediately
7/7 U
321