Siemens SINUMERIK 808D Parameter Manual page 128

Machine data
3.3 Channel-specific machine data
Bit 0 (LSB) = 0: corresponds to the behavior of SW release 1, is only recommended for
test mode
Initial setting after ramp-up:
- G codes according to MD20150 $MC_GCODE_RESET_VALUES
- Tool length offset not active
- Transformation not active
- No coupled-motion axis groupings active
- No tangential correction active
- No axial revolutional feedrate active
- Path revolutional feedrate with master spindle (default))
Initial setting after reset or end of part program:
The current settings are retained.
When next part program is started, the following initial setting is effective:
- G codes according to MD20150 $MC_GCODE_RESET_VALUES
- Tool length offset not active
- Transformation not active
- No coupled-motion axis groupings active
- No tangential correction active
- No master value coupling active
- No axial revolutional feedrate active
- Path revolutional feedrate with master spindle (default)
Bit 0 (LSB) = 1: Standard value for Powerline and Solutionline systems
Initial setting after startup:
- G codes acc. to MD20150 $MC_GCODE_RESET_VALUES
- Tool length offset active acc. to MD20120 $MC_TOOL_RESET_VALUE, MD20130
$MC_CUTTING_EDGE_RESET_VALUE, and MD20132 $MC_SUMCORR_RESET_VALUE
- Transformation active acc. to MD20140 $MC_TRAFO_RESET_VALUE
- Geometry axis replacement acc. to MD20118 $MC_GEOAX_CHANGE_RESET
- No coupled-motion axis groupings active
- No tangential correction active
Initial setting after reset or end of part program:
Depending on MD20152 $MC_GCODE_RESET_MODE, the current settings are retained for the
G groups or the initial settings stored in MD20150$MC_GCODE_RESET_VALUES are set.
Initial setting after reset or end of part program
Depending on MD20110 $MC_RESET_MODE_MASK bits 6 to 7, for
- Tool length offset
- Transformation
either the current settings are retained or the initial settings saved in the MDs are
set.
Depending on bits 8 and 9, the current settings of coupled-motion axes or tangentially
corrected axes are either deactivated or retained.
Configured synchronous spindle coupling:
The coupling is deselected depending on the setting in MD21330 $MC_COUPLE_RESET_MODE_1.
Non-configured synchronous spindle coupling:
Depending on bit 10, the coupling is either deactivated or retained.
Depending on bit 14, the basic frame is either retained or deselected.
Bit 1 = 0:
Auxiliary function output (D,T,M) at the PLC for tool selection corresponding to
machine data
MD20120 $MC_TOOL_RESET_VALUE
128
Parameter Manual
List Manual, 01/2017