Siemens SINUMERIK 808D Parameter Manual page 333

The rapid traverse feedrate must be entered in SD42160
$SC_EXTERN_FIXED_FEEDRATE_F1_F9[0].
42162 EXTERN_DOUBLE_TURRET_DIST
- Double turret head tool distance
-
- -
Description:
Distance between both tools of a double turret head.
42200 SINGLEBLOCK2_STOPRE
- Activate SBL2 debug mode
-
- -
Description:
Value = TRUE:
A preprocessing stop is made with every block if SBL2 (single block with stop after
every block) is active. This suppresses the premachining of part program blocks. This
variant of the SBL2 is not true-to-contour.
This means that a different contour characteristic might be generated as a result of
the preprocessing stop than without single block or with SBL1.
Application: Debug mode for testing part programs.
42440 FRAME_OFFSET_INCR_PROG
- Work offsets in frames
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
0:
delta is traversed after a frame change. Work offsets in FRAMES are only traversed when
an absolute position is specified.
1:
traversed after a frame change (standard response up to software version 3).
Related to ....
SD42442 $SC_TOOL_OFFSET_INCR_PROG
42442 TOOL_OFFSET_INCR_PROG
- Tool length compensations
-
808d-me42 -
808d-me62 -
808d-te42 -
Parameter Manual
List Manual, 01/2017
0., 0., 0., 0., 0., 0., 0.,
0....
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
FALSE
FALSE
FALSE
FALSE
TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
When incremental programming is used on an axis, only the programmed position
When incremental programming is used on an axis, changes to work offsets are
FALSE
FALSE
FALSE
-
DOUBLE
0.0 -
-
BOOLEAN
0 -
-
BOOLEAN
0 -
0 -
0 -
0 -
0 -
0 -
-
BOOLEAN
0 -
0 -
0 -
NC setting data
FBFA
Immediately
7/7 U
BA
Immediately
7/7 U
K1, K2
Immediately
2/2 M
2/2 M
2/2 M
2/2 M
7/7 U
7/7 U
W1, K1
Immediately
2/2 M
2/2 M
2/2 M
333