Siemens SINUMERIK 808D Parameter Manual page 363

Description:
Spindle speed at spindle start by NC/PLC interface signals DB380x DBX5006.1 (Spindle
start clockwise rotation) and DB380x DBX5006.2 (Spindle start counterclockwise
rotation).
Example:
Spindle 1 is started at a speed of 600 rpm upon detection of the positive edge of one
of the above-mentioned VDI starting signals.
Speed programming values are entered in the SD by setting bit 4=1 in MD35035
$MA_SPIND_FUNCTION_MASK.
The SD becomes active in JOG mode as a default speed by setting bit 5=1 in MD35035
$MA_SPIND_FUNCTION_MASK (exception: the value is zero).
Related to:
43202 SPIND_CONSTCUT_S
m/min Const cut speed for spindle start by VDI
-
- -
Description:
Definition of the constant cutting speed for the master spindle.
The setting data is evaluated at spindle start by the NC/PLC interface signals DB380x
DBX5006.1 (Spindle start clockwise rotation) and DB380x DBX5006.2 (Spindle start
counterclockwise rotation)
Cutting speed programming values are entered in the SD by setting bit 8=1 in MD35035
$MA_SPIND_FUNCTION_MASK.
Related to:
43206 SPIND_SPEED_TYPE
- Spindle speed type for spindle start through VDI
-
- -
Description:
Definition of the spindle speed type for the master spindle.
The range of values and the functionality correspond to the 15th G group "feed type".
Permissible values are the G values: 93, 94, 95, 96, 961, 97, 971 and 973.
The stated values make a functional distinction between the following variants:
==>
$SA_SPIND_S.
==>
43202 $SA_SPIND_CONSTCUT_S and the radius of the transverse axis.
==>
The default value is 94 (corresponds to G94)
The default value becomes active if the SD is written with impermissible values.
43210 SPIND_MIN_VELO_G25
rev/min Programmed spindle speed limitation G25
-
- -
Parameter Manual
List Manual, 01/2017
SD43200 $SA_SPIND_S[S1] = 600
MD35035 $MA_SPIND_FUNCTION_MASK
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
0.0
MD35035 $MA_SPIND_FUNCTION_MASK
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
94
93, 94, 95, 97 and 971: The spindle is started at the speed in SD 43200
96 and 961: The speed of the spindle is derived from the cutting speed of SD
973: G973 behaves like G97, but the spindle speed limitation is not active
0.0
-
DOUBLE
0.0 -
A06
DWORD
93 973
-
DOUBLE
0.0 -
NC setting data
S1
Immediately
7/7 U
-
Immediately
7/7 U
S1
Immediately
7/7 U
363