Siemens SINUMERIK 808D Parameter Manual page 193

24040 FRAME_ADAPT_MODE
- Adaptation of active frames
-
- -
Description:
Bit mask for adapting the active frames or axis configuration
The following applies:
Bit 0:
Rotations in active frames that rotate coordinate axes for which there are no geometry
axes are deleted from the active frames.
Bit 1:
Shear angles in active frames are orthogonalized.
Bit 2:
Scalings of all geometry axes in the active frames are set to value 1.
24050 FRAME_SAA_MODE
- Saving and activating of data management frames
-
- -
Description:
Bit mask for saving and activating data management frames.
The following applies:
Bit 0:
Data management frames are only activated by programming the bit masks $P_CHBFRMASK,
$P_NCBFRMASK and $P_CHSFRMASK. G500..G599 only activate the relevant settable frame,
GFRAME0..GFRAME100 only activate the corresponding grinding frame. The reset behavior
is independent of this.
Bit 1:
Data handling frames are not written implicitly by system functions such as TOROT,
PAROT, ext. work offset, transformations.
24080 USER_FRAME_POWERON_MASK
- Parameterize properties for settable frame
-
- -
Description:
Setting the following bits activates certain properties of the settable frame:
Bit 0 = 0: default behavior.
Bit 0 = 1: if MD20152 $MC_GCODE_RESET_MODE[7] = 1, the last active settable frame is
selected again according to G code group 8 after power up of the control.
24100 TRAFO_TYPE_1
- Definition of transformation 1 in channel
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Parameter Manual
List Manual, 01/2017
0x0, 0x0, 0x0, 0x0, 0
0x0, 0x0, 0x0, 0x0...
0x0, 0x0, 0x0, 0x0, 0
0x0, 0x0, 0x0, 0x0...
0x0, 0x0, 0x0, 0x0, 0
0x0, 0x0, 0x0, 0x0...
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
3.3 Channel-specific machine data
C03 K2
DWORD PowerOn
0x0000007 1/1
C03 -
DWORD PowerOn
0x0000003 1/1
N01 -
DWORD PowerOn
0x1 7/2
C07 F2, TE4, M1, K1, W1
DWORD NEW CONF
- 1/1
- 1/1
- 1/1
- 1/1
- 7/7
- 7/7
Machine data
M
M
M
M
M
M
M
U
U
193