Siemens SINUMERIK 808D Parameter Manual page 349

between the start and the end angle. SD42692 $SC_JOG_CIRCLE_MODE bit 0 defines the
direction from the start to the end angle. If start and end angle equal zero, no
limitation is active.
This setting data is written via the user interface.
42694 JOG_CIRCLE_END_ANGLE
degrees Circle end angle
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This setting data defines the end angle during JOG of circles.
The end angle refers to the abscissa of the current plane. Traversing is only possible
within the range
between the start and the end angle. SD42692 $SC_JOG_CIRCLE_MODE bit 0 defines the
direction from the start to the end angle. If start and end angle equal zero, no
limitation is active.
This setting data is written via the user interface.
42700 EXT_PROG_PATH
- Program path for external subroutine call EXTCALL
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
The total path results from the string chaining of SD42700 $SC_EXT_PROG_PATH + the
programmed subprogram identifier.
42750 ABSBLOCK_ENABLE
- Enable base block display
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
Parameter Manual
List Manual, 01/2017
0, 0, 0, 0, 0, 0, 0, 0... 0
0, 0, 0, 0, 0, 0, 0, 0... 0
0, 0, 0, 0, 0, 0, 0, 0... 0
0, 0, 0, 0, 0, 0, 0, 0... 0
0, 0, 0, 0, 0, 0, 0, 0... 0
0, 0, 0, 0, 0, 0, 0, 0... 0
- -
- -
- -
- -
- -
- -
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
- -
DOUBLE Immediately
360 2/2
360 2/2
360 2/2
360 2/2
360 7/7
360 7/7
- K1
STRING Immediately
- 3/3
- 3/3
- 3/3
- 3/3
- 7/7
- 7/7
- K1
BOOLEAN Immediately
- 1/1
- 1/1
- 1/1
- 1/1
NC setting data
M
M
M
M
U
U
U
U
U
U
U
U
M
M
M
M
349