Siemens SINUMERIK 808D Parameter Manual page 439

Hide thumbs Also See for SINUMERIK 808D:
Table of Contents

Advertisement

Signal state 1
Signal state 0
Note for the reader
DB380x
DBX1000.7
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB380x
DBX1002.1
Edge evaluation: No
Signal state 1
Signal state 0
corresponding to ...
Note for the reader
DB380x
DBX2000.0 to .2
Edge evaluation: Yes
Parameter Manual
List Manual, 01/2017
2nd software limit switch for the plus or minus direction is active.
1st software limit switch for the plus or minus direction is inactive.
In addition to the 1st software limit switches (plus or minus), 2nd software
limit switch (plus or minus) can be activated via these interface signals.
The position is defined using MD36130 POS_LIMIT_PLUS2,
MD36120 POS_LIMIT_MINUS2 (2nd software limit switch plus, 2nd software
limit switch minus).
1st software limit switch for the plus or minus direction is active
2nd software limit switch for the plus or minus direction is inactive
Function Manual Basic Functions A3
Reference point approach deceleration
Signal(s) to axis / spindle (PLC → NCK)
Signal(s) updated: Cyclic
The machine axis is positioned at the reference cam.
The machine axis is positioned in front of the reference cam. An appropriately
long reference cam (up to the end of the traversing range) should be used
to prevent the machine axis from being located behind (after) the referencing
cam.
Function Manual Basic Functions R1
Activate the program test
Signal(s) to axis / spindle (PLC → NCK)
Signal(s) updated: Cyclic
Activation of the program test is requested.
During the program test, all motion commands of axes (not spindles) take
place under "Axis disable."
Notice!
Because of the axis disable, the assignment of a tool magazine is not
changed during program testing. The user/machine manufacturer must uti‐
lize a suitable PLC user program to ensure that the NCK-internal tool man‐
agement and the actual assignment of the tool magazine remain consistent.
Refer to the program example included in the PLC Toolbox.
Activation of the program test is not requested.
DB1700 DBX1.7 (program test selected)
DB3300 DBX1.7 (program test active)
Function Manual Basic Functions K1
Actual gear stage A to C
Signal(s) to axis / spindle (PLC → NCK)
Signal(s) updated: Cyclic
Detailed descriptions of interface signals
5.8 Axis / spindle-specific signals
439

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik808d advanced

Table of Contents