Global Access Settings; Card Type - Bosch B9512G Program Entry Manual

Control Panel
For a D9210C or B901 on the SDI bus (Door Source = SDI) shorting the tamper input (T+) to
common (COM) creates a Point Missing event for the Door Point, page 228.
For a B901 on the SDI2 bus (Door Source = SDI) shorting the tamper input (T+) to common
(COM) creates a Point Missing event for the Door Point, page 228 and a Tamper event for the
B901 module.
RPS Menu Location
Access > Doors > Enclosure Tamper
See also
–
12.2

Global Access settings

12.2.1

Card Type

Default: 26 bit
Selections:
26 bit
37 bit no site code
37 bit with site code
This parameter specifies the card or token format used for all of the door controllers and
keypads.
Notice!
Set to 26 bit when credentials (card or token) are used with a B942.
Default Site Code, page 147 for card types
26 bit: default site code is 255.
37 bit no site code: default site code is blank. The site code is not configurable (Site Code
parameter is grayed out).
37 bit with site code: default site code is 65535.
RPS Menu Location
Access > Global Keypad Settings > Card Type
Bosch Security Systems, Inc.
Door Point, page 228
Program Entry Guide
Access | en 235
2017.03 | 09 | F.01U.303.998