Remote Access; Remote Pc - Bosch AMAX panel 2100 Installation Manual

46 en | Settings
When the report is transmitted with Conettix IP Communication, some reports might be
missed. It is recommended not to separately use the ITS-DX4020-G module. If the ITS-DX4020-
G module is used, other network modules (e.g. B426) or the public telephone network can be
set as backup channel to ensure that no reports are missed.
The communication path of B426 / ITS-DX4020-G / B 450 is as follows:
Module
Module 1: B426 module 1 / ITS-
DX4020-G / B 450
Module 2: B426 module 2 / B450
Only when IP module 1 is used and set to paths 1 to 4, the report can be sent to those paths.
6.1.5

Remote Access

The AMAX panel supports remote programming via USB, telephone, or IP network using the
software A-Link Plus. The following option can be performed:
–
–
–
–
–
Remote Access Armed
–
Remote programming
–
6.1.6

Remote PC

IP Address and port number
RPC IP address is a fixed IP address for remote programming software.
RPC port number is the port number for remote programming.
How to program an IP address and port:
1.
2.
3.
4.
5.
Example
4
2015.05 | 06 | F.01U.309.277
All manuals and user guides at all-guides.com
Setting the date and time
Uploading / downloading programming parameters
Remote arming / disarming of each area
Enabling / disabling the alarm siren of each area
Enabling / disabling each output
This option enables / disables the remote access for the function alarm.
This option enables / disables the remote access for programming. If this function is
disabled, the system can not be programmed via an IP network anymore.
Program an IP address with 17 digits: digits 1 - 12 for the IP address and 13 - 17 for the
port.
Use no punctuation in the IP address.
If any unit of the IP address has less than 3 digits, use 0 to fulfill the data in the higher
bits.
The remaining 5 digits program the port. Port number ranges from 0-65535.
If a port number has less than 5 digits, use 0 to fulfill the data.
To program the IP address "10.16.1.222:80", enter the following sequence into the
correspondent address:
[0 1 0 0 1 6 0 0 1 2 2 2 0 0 0 8 0]
Installation Manual
Address Setting
134
250
AMAX panel
Corresponding
Communication Path
Paths 1 and 2
Paths 3 and 4
Bosch Sicherheitssysteme GmbH