152 en | User Configuration
This function allows the user to test 24-hour points in areas within the Scope of the keypad
where the function is entered.
Controlled points, Point Type, cannot be tested using the fire walk test mode. 24-Hour points
left off-normal when exiting the Fire Test are bypassed. A trouble tone sounds until it is
silenced. The keypads alternate text with the Bypass indications.
RPS Menu Location
User Configuration > User Keypad Functions > Walk Test All Fire Points
Further information
Point Type, page 184
9.3.11
Send Report (Test/Status)
Default: E
Selections: - , E, P
–
–
–
This function tests the communication link between the control panel and the central station
receiver(s).
This parameter can send a test report or a status report to the phone numbers as
programmed in Phone Routing. Reports can also be sent to an IP address if programmed. The
test report includes additional information if Expand Test Rpt is enabled in the Phone section.
RPS Menu Location
User Configuration > User Keypad Functions > Send Report (Test/Status)
9.3.12
Door Control
Default: P
Selections: - , E, P
–
–
–
This function allows the user to access the cycle door, unlock door, and secure door functions.
Use this feature when programming door control in your function menu.
RPS Menu Location
User Configuration > User Keypad Functions > Door Control
9.3.13
Set Keypad Brightness / Volume / Keypress
Default: E
Selections: - , E, P
–
–
–
This function allows the user to select either a bright or dim display with loud or soft keypad
warning tones.
RPS Menu Location
User Configuration > User Keypad Functions > Set Keypad Brightness/Volume/Keypress
9.3.14
Set/Show Date and Time
Default: P
Selections: - , E, P
2017.03 | 09 | F.01U.303.998
Disable (-) - Disable this function panel wide regardless of the user's authority level.
Enable (E) - Enable this function panel wide without requiring a passcode.
Passcode (P) - Require a passcode to enable this function panel wide.
Disable (-) - Disable this function panel wide regardless of the user's authority level.
Enable (E) - Enable this function panel wide without requiring a passcode.
Passcode (P) - Require a passcode to enable this function panel wide.
Disable (-) - Disable this function panel wide regardless of the user's authority level.
Enable (E) - Enable this function panel wide without requiring a passcode.
Passcode (P) - Require a passcode to enable this function panel wide.
Program Entry Guide
Control Panel
Bosch Security Systems, Inc.