Access Granted Events; Access Denied Events; Answer Rps; Contact Rps - Bosch B9512G Program Entry Manual

222 en | Schedules
11.5.22

Access Granted Events

This function is not available as a keypad shortcut function and determines whether access
granted events are saved in the control panels event log.
When Parameter 1: Access Level is set to On, the doors programmed in Parameter 2: Door #
will put their access granted events in the control panel event log.
When Parameter 1: Access Level is set to Off, the doors programmed in Parameter 2: Door #
will not put their access granted events in the control panel event log.
11.5.23

Access Denied Events

This function is not available as a keypad shortcut function and determines whether access
denied events are saved in the control panels event log.
When Parameter 1: Access Level is set to On, the doors programmed in Parameter 2: Door #
will put their access denied events in the control panel event log.
When Parameter 1: Access Level is set to Off, the doors programmed in Parameter 2: Door #
will not put their access denied events in the control panel event log.
11.5.24

Answer RPS

This function emulates the keypad short cut Answer RPS which causes the control panel to
answer the next request from RPS to establish a session via phone or network. This function is
only available in a custom function. This auto-answer period will last for 2 minutes and
overrides the Answer RPS Over Network? and RPS Address Verification prompt settings.
11.5.25

Contact RPS

This function attempts to contact an Unattended RPS at the configured time. The control
panel's account in RPS controls the operations performed upon successful contact.
Notice!
Avoid having multiple functions occur at the same time at the same address. Functions can
clash and the effect on the panel is unpredictable.
Notice!
Do not program multiple Skeds to execute at the same keypad during the same time of
execution.
Notice!
Do not program Skeds to execute at times when a user is likely to be executing functions at
the keypad.
11.5.26

Contact RPS User Port

This function attempts to contact Unattended RPS at the configured time over a network
communication device at the configured port. The control panel's account in RPS controls the
operations performed upon successful contact.
11.5.27

Send Status Report

This function generates a status report for each area that is enabled. The report is sent to the
Phone(s) programmed for Test and Status Reports in Report Routing.
2017.03 | 09 | F.01U.303.998 Program Entry Guide
Control Panel
Bosch Security Systems, Inc.