Buzz On Fault; Watch Point - Bosch B9512G Program Entry Manual

Control Panel
RPS Menu Location
Points > Point Indexes > Invisible Point
10.3.12

Buzz on Fault

Default:
–
–
Selections: 0 to 3
This parameter brings attention to a faulted point by generating a trouble buzz even if the
point is not actually in trouble.
Instant Alarm (I), Trouble (T) and Supervisory (S) point responses take priority over Buzz on
Fault. If the point response is "blank", then Buzz on Fault can be the only response. Refer to
the Point Response, page 184 configuration for a description of response types for each point
type and how they are affected by arm state.
If an alarm, trouble or supervisory event occurs and is silenced, then Buzz on Fault selections
1 and 3 will persist until the point returns to normal.
Refer to the following table for Buzz on Fault controlled point operation and 24-hour point
operation:
Selection
0
1
2
3
Notice!
Custom Function point types do not support Buzz on Fault.
RPS Menu Location
Points > Point Indexes > Buzz on Fault
10.3.13

Watch Point

Default:
–
–
Selections:
Bosch Security Systems, Inc.
Point Index 9: 1
All other Point Indexes: 0
Buzz on fault
Disabled
Yes
Yes
Yes
Point Indexes 7 to 8: Yes
All other Point Indexes: No
Silence while
faulted
Does not apply
Not allowed
Allowed
Not allowed
Program Entry Guide
Points | en 193
Silence after Description
restore
Does not apply Buzz on Fault
feature is
disabled.
Allowed Buzz persists
until the point
restores and is
silenced.
Allowed Buzz can be
silenced.
Auto silence Buzz persists
until the point
restores.
2017.03 | 09 | F.01U.303.998