Bosch B9512G Program Entry Manual page 281

Control Panel
Figure 16.2: Open Account Assistant
If you choose not to use not to use the Account Assistant, follow the steps below to configure
a control panel account for cellular service.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Panel Wide Parameters > Enhanced Communication, page 62: set reporting Destinations,
11. Panel Wide Parameters > Personal Notification > Personal Notification Destinations, page
Bosch Security Systems, Inc.
In the Panel List, right-click the panel account you want to configure for cellular service,
then click Open Panel Data - View.
Click the Cellular tab.
Press F1 to open the help for the Cellular tab.
Follow the instructions to enter information in the Cellular Connectivity fields. RPS uses
the SIM or radio MEID number to retrieve and store the assigned IP address, phone
number and assigned plan.
Click Show Plans, and then click Plan Help. Select an appropriate plan to avoid overage
fees.
Click OK when you're finished. You're back to the Panel List.
To set panel parameters, in the Panel List, right-click the panel account you clicked in
step 1, then click Open Panel View.
Panel Wide Parameters > Cellular Plug-in Module, page 36: leave the parameters here at
their defaults. Only change for UL1610 commercial listed installations requiring low signal
notification.
Panel Wide Parameters > Communicator, overview, page 58 > Primary Destination Device
(Backup Destination Device): to send reports for a Route Group via a cellular
communicator, select a (Plug-in) Cellular Destination as the Primary (or Backup)
Destination.
and polling/supervision settings here. Be sure cellular polling rates follow recommended
settings and align with your cellular plan.
85: set phone numbers for SMS messages, email addresses for email messages. Set
Method to Plug in Cellular SMS, Bus Device Cellular SMS, Plug in Cellular Email, or Bus
Device Email.
Program Entry Guide
Configuring for Cellular Service | en 281
2017.03 | 09 | F.01U.303.998