Table of Contents
Advertisement
.
13.0 Programmer Connections
13.1
Programmer Connector
Refer to the D5200 Operation Manual
(P/N: 74-06176-000) for complete information on using
the D5200 programmer.
To connect and disconnect the programmer:
1. Lock the Reset Pin (Figure 24).
2. Connect the D5200 Data/Power cord to the
programming connector on the control panel.
3. Perform the desired programming function (send
or receive program).
4. Disconnect the programmer.
Figure 24: Reset Pin
Reset Pin
Disable All Except Battery
Charging And Programming
PERIPHERAL DEVICE CONNECTIONS
32
RED
POWER +
31
YELLOW
DATA BUS A
30
GREEN
DATA BUS B
29
BLACK
COMMON
1 - Reset Pin locked (closed)
2 - Reset Pin normal (open) for normal control
panel operation
13.2
Programmer Access Reports
When a program is sent to the control panel, the
control panel sends a Prog Access OK report ten
seconds after the handler exits or when the
programmer disconnects. The prompt in routing must
be programmed Yes to send this report.
Bosch Security Systems, Inc. | 5/05 | F01U003805B
D7212GV2 | Operation and Installation Guide | 13.0
1
2
Programmer Connections
51
Advertisement
Table of Contents
