Access Control Functions - Bosch D9412GV4 Program Entry Manual

96 en | Panel and Area Wide Parameters
View Memory
Default:
Selection:
Function No.
9
Use this function to view prior alarm, trouble, and supervisory activity occurring since the last
time the system armed. Event memory is not cleared until the area re-arms.
View Point Status
Default:
Selection:
Function No.
10
Use this function to view points assigned to the area where the keypad is assigned. This
function shows point text and the electrical condition (normal, open, short, and missing) of
each point in the area.
Walk Test
Default:
Selection:
Function No.
11
Use this function to test Controlled points in areas within the keypad's scope without sending
reports to the central station. 24-hour points cannot be tested using this Walk Test Mode.
Fire Test
Default:
Selection:
Function No.
12
Use this function to test 24-hour points in areas within the scope of the keypad where the
function is entered. Controlled points, P## Type 1, 2, 3, cannot be tested using the Fire Walk
Test Mode.
Send Report
Default:
Selection:
Function No.
13
Use this function to test the communication link between the control panel and the central
station receiver(s). It can send a Test Report or a Status Report to the phone numbers
programmed in Routing. The Test Report includes additional information if Expand Test
Report is enabled in Section 3.1 Phone, page 17.
3.12.3

Access Control Functions

Door Control
Default:
Selection:
F.01U.218.312 | 04 | 2012.03
E
-, E, or P
Function Name
View Event Memory
E
-, E, or P
Function Name
View Point Status
E
-, E, or P
Function Name
Walk Test
P
-, E, or P
Function Name
Fire Test
E
-, E, or P
Function Name
Send Report
P
-, E, or P
Program Entry Guide
D9412GV4/D7412GV4/D7212GV4
Alternate Keystroke
[COMMAND][4][0]
Alternate Keystroke
(Menu function only)
Alternate Keystroke
[COMMAND][4][4]
Alternate Keystroke
[COMMAND][5][8]
Alternate Keystroke
[COMMAND][4][1] or [COMMAND][4][2]
Bosch Security Systems, Inc.