Area Wide Outputs; Alarm Bell; Fire Bell - Bosch B9512G Program Entry Manual

Control Panel
Check output status after reprogramming or resetting the control panel. All outputs are turned
off after the control panel is reset. Certain output functions are checked by the control panel
each minute and will resume the correct state after the reset. Other outputs must be manually
set to the correct state using the Change Output function (MENU 32).
These output functions resume the proper state within one minute:

Fire Bell

Summary Fire
Summary Trouble
Silent Alarm
Summary SupFire
Summary Fire Tbl
These output functions need to be manually reset with Change Output function:
Fail To Close
Duress
8.1

Area Wide Outputs

8.1.1

Alarm Bell

Default: 1
Selections:
–
–
This output activates when an intrusion point assigned to this area goes into alarm. It will also
activate for (non-fire) keypad and keyfob alarms that are configured to sound the Alarm Bell.
Notice!
To comply with SIA CP-01 False Alarm Reduction, set this parameter to a value other than 0
for each enabled area. Refer to SIA CP-01 Verification for more information.
Burg Time, page 100 and Burg Pattern, page 101 must be programmed. This output activates
according to the bell pattern and remains active until the bell time expires or is manually
silenced. Silent Alarm, page 137 must be set to No in order for the bell to ring upon alarm.
Each area can be assigned a unique output number for each of the events listed in this
section.
RPS Menu Location
Output Parameters > Area Wide Outputs > Alarm Bell
8.1.2 Fire Bell
Default: 1
Selections:
–
–
This output activates when a fire point assigned to this area goes into alarm. It will also
activate for keypad fire alarms.
Fire Time and Fire Pattern must be programmed in Bell Parameters. This output activates
according to the bell pattern and remains active until the bell time expires or is manually
silenced. Silent Bell must be set to No in order for the bell to ring upon alarm.
Bosch Security Systems, Inc.
B9512G: 0 to 599
B8512G: 0 to 99
B9512G: 0 to 599
B8512G: 0 to 99
Area Fault
Summary Alarm
Phone Fail
Watch Mode
Alarm Bell
Area Armed
Force Armed
Log % Full
Program Entry Guide
Output Parameters | en 133
Part On Fault
AC Fail
Communications Fail
Reset Sensors
Battery Trouble
Summary SupBurg
2017.03 | 09 | F.01U.303.998