Bosch B9512G Program Entry Manual page 47

Control Panel
Auto Function Reports, page
User Change Reports, page
Selections:
Yes - assign all of the reports in this category to the Route Group.
No - assign all of the reports in this category to the Route Group.
Custom - you can not select Custom. Custom shows for a category when at least one of the
reports in the category is configured individually.
Notice!
Configuration for individual reports lost on change from Custom to Yes or No
When Custom appears for a category of reports, it indicates that not all of the reports are set
the same (all Yes or all No). The reports have been set individually.
If you change the reports for a category from Custom to Yes or No, the configuration for the
individual reports in the category is lost. To individually re-assign reports from a report
category to a Route Group, you must click on the report category in the menu tree, Fire
Reports, page 51 for example.
RPS Menu Location
Panel Wide Parameters > Report Routing
Fire Reports
Reports in the Fire category:
–
–
–
–
–
–
–
–
–
To individually assign reports from the Fire category to a Route Group, click Fire Reports, page
51 in the menu tree.
Bosch Security Systems, Inc.
Report Category
User Reports, page 48
Test Reports, page 49
Diagnostic Reports, page
49
Output Reports, page 50
50
RPS Reports, page 50
Point Reports, page 50
50
Access Reports
Fire Alarm
Fire Restoral (After Alarm)
Fire Missing
Fire Trouble
Fire Supervision
Fire Restoral (After Trouble)
Fire Cancel
Fire Supervision Missing
Fire Supervision Restoral
Route Group 1 Route Group 2 Route Group 3 Route Group 4
Custom Custom
Yes Yes
Custom Custom
Yes Yes
Yes Yes
Custom Custom
Yes Yes
Yes Yes
Yes Yes
Program Entry Guide
Panel Wide Parameters | en
Custom Custom
Yes No
Custom Custom
Yes Custom
Yes No
Custom No
Yes No
Yes Custom
Yes Yes
2017.03 | 09 | F.01U.303.998
47