Control Panel
To calculate the switch settings for POPITS, you must determine the value to use in the
calculation. For addresses 9 through 127, subtract 9. For addresses 129 through 247, subtract
129. Use the following procedure with address 48 as the example, substituting the actual
values in your calculation.
1.
2.
10.11
D9210C Access Control Interface Module Rotary Address
Switch Settings
For additional information, refer to the D9210C Access Control Interface Module Installation and
Operation Guide.
10.12
D1255, D1260, D1265 Dip Switch Settings
For additional information, refer to:
–
–
–
Notice!
The D1265 keypad has not been investigated by UL.
–
10.13
D8129 OctoRelay Dip Switch Settings
For additional information, refer to the D8129 OctoRelay Module Operating and Installation
Guide.
10.14
D8128D OctoPOPIT Dip Switch Settings
For additional information, refer to the D8128D OctoPOPOIT Module Installation Guide.
Bosch Security Systems, Inc.
Subtract 9 from 48. The result is 39.
Set the switches that add up to 39 to the OFF positions (32 + 4 + 2 + 1 = 39).
SW 1 OFF = 32
SW 4 OFF = 4
SW 5 OFF = 2
SW 6 OFF = 1
D1255/D1255B Keypads Installation Instructions
D1260/D1260B Keypads Installation Guide
D1265 Keypads Installation Guide
Quick Reference Guide
Device Address Settings | en
2014.05 | 05 | F.01U.265.463
25