Service Walk All Points; Send Report (Test / Status) - Bosch B9512G Program Entry Manual

Control Panel
This function allows a user with Invisible Walk Test authority to test invisible interior or
perimeter controlled points that are within the scope of the keypad without sending a report
to the central station.
Invisible points must have the Invisible Point, page 192 parameter set to Yes.
24-Hour points left off-normal when exiting the Invisible Walk Test are bypassed. A trouble
tone sounds until it is silenced. The keypads will alternate text with the Bypass indications.
RPS Menu Location
User Configuration > Authority Levels > Walk Test All Invisible Burg Point
9.4.15

Service Walk All Points

Default:
Authority Levels 1, 15: 1, Enabled (E)
Authority Levels 2-14: Blank (-)
Selections:
–
–
This parameter allows the user with this authority level to initiate a service walk test for all 24
hour interior and perimeter controlled points in the control panel.
Points are not included in this test if
–
–
–
When a Service Walk Test is initiated, one person can test all the points in the control panel
without assistance.
Points 128 and 248 are not accessible by this function. This is normal. This function allows
viewing of extra points. Extra points can occur when:
–
–
–
Authority Level 15 is reserved for the Service Passcode (User 0) and cannot be changed.
24-Hour points left off-normal when exiting the Service Walk Test are bypassed. A trouble tone
sounds until it is silenced. The keypads will alternate text with the Bypass indications.
RPS Menu Location
User Configuration > Authority Levels > Service Walk All Points
9.4.16

Send Report (Test / Status)

Default:
Authority Levels 1, 15: Enabled (E)
Authority Levels 2-14: Blank (-)
Selections:
–
–
This parameter allows the user with this authority level to send a test report from any keypad
assigned to an area where the user has authority.
Authority Level 15 is reserved for the Service Passcode (User 0) and cannot be changed.
RPS Menu Location
User Configuration > Authority Levels > Send Report (Test/Report)
Bosch Security Systems, Inc.
Blank (-): This function is not authorized for the user who is assigned this authority level.
Enabled (E): This function is authorized for the user who is assigned this authority level.
points are in an area that is already in any walk test mode
points are assigned to an area that is not enabled (Area On), or
points are in an area that is All or Part On.
Point Source is set to anything other than Unassigned,
Point Index is set to 0, or
At least two points are installed for the same Point Assignment on different Point
Sources.
Blank (-): This function is not authorized for the user who is assigned this authority level.
Enabled (E): This function is authorized for the user who is assigned this authority level.
Program Entry Guide
User Configuration | en 163
2017.03 | 09 | F.01U.303.998