Address-Family - Dell N1100-ON Reference Manual

ASNs 0, 56320–64511, and 65535 are reserved and cannot be used.
Command History
Introduced in version 6.2.0.1 firmware.
Example
The following example creates a BGP routing instances and enables BGP
routing for AS 4324
console(config)#router bgp 4324

address-family

Use the address-family command in peer template configuration mode to
configure policy parameters within a peer template to be applied to a specific
address family. To delete all policy commands for an address family in a peer
template, use the no form of this command
Syntax
address-family { ipv4 | ipv6 }
no address-family { ipv4 | ipv6 }
• ipv4—Configure policy parameters to be applied to IPv4 routes.
• ipv6—Configure policy parameters to be applied to IPv6 routes.
Default Configuration
No peer templates are configured by default.
Command Mode
Peer Template Configuration mode
User Guidelines
This command enters address family configuration mode within the peer
template. Policy commands configured within this mode apply to the address
family. The following commands can be added to a peer template in address
family configuration mode:
• activate
.
Layer 3 Routing Commands
1216