Dell N1100-ON Reference Manual page 1200

Command Mode
User Exec and Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
The show arp command will display static (user-configured) ARP entries
regardless of whether they are reachable over an interface or not.
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
Example
The following example shows show arp command output.
console#show arp
Static ARP entries are only active
when the IP address is reachable on a local subnet
Age Time (seconds)............................. 1200
Response Time (seconds)........................ 1
Retries........................................ 4
Cache Size..................................... 6144
Dynamic Renew Mode............................ Disable
Total Entry Count Current / Peak.............. 0 / 0
Static Entry Count Configured / Active / Max .. 1 / 0 / 128
IP Address MAC Address
---------- -------------- ---------
1.1.1.3 0000.0000.0022
Interface Type
------ -------
n/a Static n/a
Age
Layer 3 Routing Commands
1200