Detail; Color Wheel; Master Wheel; Reset Buttons - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Detail

Use this setting to sharpen the image from your cameras live. Decrease or increase the
level of sharpening by selecting: Detail off, detail default for low sharpening, medium
detail, and high detail.

Color Wheel

The color wheel is a powerful feature of the DaVinci Resolve color corrector and used
to make color adjustments to each YRGB channel's lift, gamma and gain settings. You
can select which setting to adjust by clicking on the three selection buttons above the
color wheel.

Master Wheel

Use the master wheel below the color wheel to make contrast adjustments to all YRGB
channels at once, or luminance only for each lift, gamma or gain setting.

Reset Buttons

The reset button near the bottom right of each camera controller lets you easily choose
color correction settings to reset, copy or paste. Each color wheel also has its own
reset button. Press to restore a setting to its default state, or copy/paste a setting.
Locked controllers are not affected by the Paste feature.
The master reset button on the bottom right corner of the color corrector panel lets you
reset lift, gamma and gain color wheels plus Contrast, Hue, Saturation and Lum Mix
settings. You can paste color correction settings to camera controllers individually, or all
cameras at once for a unified look. Iris, focus, coarse and pedestal settings are not
affected by the Paste feature. When applying Paste to all, a warning message will appear
asking you to confirm your action. This is so you don't accidentally paste new settings to
any unlocked cameras that are currently on air.
When applying 'paste to all', a warning message will appear asking
you to confirm your action. This is so you don't accidentally paste
new settings to any unlocked cameras that are currently on air.
Iris/Pedestal Control
The iris/pedestal control is located within the cross hairs of each camera controller.
The control illuminates red when its camera is on air.
To open or close the iris, drag the control up or down. Holding the shift key allows only
iris adjustments.
To darken or lift the pedestal, drag the control left or right. Holding the command key
on a Mac, or the Control key on Windows, allows only pedestal adjustments.
Using ATEM Software Control 66 66