Audio Balance - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Audio Balance

The audio mixer supports stereo audio from each audio source. If you wish to change the left/
right audio channel balance for a camera or other audio source, adjust the knob to the desired
balance point.
If you are operating an ATEM switcher, excluding Television
Studio, and notice the solo and monitor settings are grayed
out, you have program audio selected for the audio out
setting in the settings window. The solo and monitor settings
are always grayed out on ATEM Television Studio.
The audio meter for Cam1 is shown in gray to indicate that its audio will not
be used as neither of its ON or AFV buttons are enabled. Cam2 has AFV
selected but its audio is not currently being used as the camera is not on air
as is indicated by its dull yellow tally light. Cam4 and Cam7 have their direct
mix set to ON so their mixed audio is always used, and their tally lights remain
lit, even if another camera is currently on air. The audio level meters for Cam3,
Cam5, Cam6 and Cam8 show that no audio is present on these cameras.
Using ATEM Software Control 46 46