Controlling Hyperdecks With Atem Broadcast Panels - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Configuring auto roll:
1
Press the 'auto roll' soft button in the HyperDeck Setup system control menu.
2 Toggle auto roll on and off by pressing the soft button under the 'auto roll' title in the
four line display.
3 When auto roll is enabled, set the number of offset frames by turning the third control
knob under the four line display.
4
Confirm your settings with the 'save' soft button
If you want to cue to a still frame or manually trigger video playback on your HyperDeck, you
can disable the 'auto roll' feature on each HyperDeck.

Controlling HyperDecks with ATEM Broadcast Panels

To control a given HyperDeck, simply press the 'HyperDeck' soft button in the system control
'home' menu and select the HyperDeck you wish to control from top row of the menu.
The system control panel LED display will provide information on which HyperDeck is
connected, the currently selected clip, and the time remaining, or time elapsed, on the current
clip. You can toggle between time elapsed and time remaining by pressing the soft button
under the fourth control knob under the LED display.
If your HyperDeck is properly connected and has a disk inserted, you will see two rows of
control buttons on the second and third rows of the HyperDeck menu. These are labelled
according to their function and control is very intuitive.
HYPER HYPER
DECK DECK
1
PREV STOP
RW PLAY
Use the HyperDeck control menu to select
and control HyperDeck disk recorders
Use the 'prev' and 'next' buttons, the rotary knob under the 'clip' heading in the LED display,
or the number pad in conjunction with the soft button under the 'clip' title in the LED display to
move between clips. The 'play,' 'stop,' 'record,' 'fast forward' and 'reverse' buttons can be used
just as you would on a VTR. When a clip is already playing, pressing the 'play' button again will
loop that clip, or loop all of your HyperDeck's media if 'play all' is selected.
You can also shuttle and jog the clips on your HyperDeck by turning the control knobs under
the 'shuttle' and 'jog' titles in the system control LED display. Just note that you will first need to
press the 'shuttle' or 'jog' knob's corresponding soft button to enable these controls; this is to
ensure that you don't accidentally shuttle through a clip while it is live to air.
You can modify the function of some HyperDeck controls with the 'shift' button on your
broadcast panel. When this is pressed, the 'play' button on your HyperDeck control menu
becomes 'play all.' This will play all of the clips on your HyperDeck disk recorder, starting with
the currently selected clip.
HYPER HYPER
DECK DECK
2 3 4
NEXT REC
FF HOME
HyperDeck Control 78 78