Changing The Switcher Network Settings - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

The control panels can be set to DHCP or fixed IP addresses. Generally when used on a
network, the control panel would be selected to DHCP, so it is automatically assigned an IP
address when connected to the network.
For all devices to communicate, they must share the same IP address subnet, which typically
means the first 3 fields in the IP address need to be the same. Each device must also use a
unique IP address.
Please remember to set all devices to the correct IP address so they can all communicate.
You will need to set the IP address of the ATEM Production Switcher via USB using Blackmagic
ATEM Setup. You will need to set the DHCP or fixed IP mode on the ATEM Broadcast Panel and
if using a fixed IP address on the panel, set the IP address on the panel. You will also need to
set the panel, switcher address to the new IP address you have just set for the switcher.
Lastly, you need to ensure your computer is connected and working on your network. Then
when you launch the ATEM Software Control application, you will be prompted automatically to
enter in an IP address for the switcher if ATEM Software Control cannot communicate with the
ATEM switcher. Use the IP address you just entered in for the switcher. Then the ATEM Software
Control can find the switcher and communicate.

Changing the Switcher Network Settings

The switcher network settings are changed using the Blackmagic ATEM Setup via USB.
Please follow the steps below:
1 Connect the switcher via USB, to the computer running the setup utility software.
2 Launch Blackmagic ATEM Setup and select your switcher or broadcast panel.
3 The switcher's current IP address, subnet mask and gateway settings will be displayed
in 'configure' window. If you only want to check the IP address and not change it,
you can simply quit the setup utility by clicking 'cancel'.
4 To change the IP address or any other settings, simply edit the numbers and then
click 'save'.
5 A dialog box will prompt you to power cycle your ATEM switcher. Turn the switcher's
power off, turn it back on and then close the dialog box.
Change network setting using the 'configure' tab in Blackmagic ATEM Setup.
Getting Started 25 25