To Perform A Stinger Transition On The Broadcast Panel; Broadcast Panel Stinger Transition Parameters - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Stinger Transition Settings

To perform a stinger transition on the broadcast panel

1 From the system control menu buttons, navigate to the media player menu by selecting
MEDIA PLAYER from the home menu and select the media player you plan to use for
the transition.
2 Select the CLIPS button and then use the first knob to select between clips 1 or 2.
3 Select stinger as the transition type by pressing the STNG button on the ATEM 2 M/E
Broadcast Panel. On the ATEM 1 M/E Broadcast Panel, pressing the DIP/MIX and
DVE/WIPE buttons simultaneously illuminates Both buttons green indicating that the
stinger transition type is selected.
4 From the system control menu buttons, select the media player you chose in step 1.
You can also navigate to the stinger menu by selecting TRANS > STINGER from the
HOME menu.
5 Adjust the preroll, trigger, mix and duration times as needed.
6 Set the logo rate and any other key parameters if required.
7 Perform the transition as an auto transition from the transition control block.
You cannot perform a manual stinger transition using the fader bar.

Broadcast panel stinger transition parameters

preroll
trigger
mix
duration
Preroll is a trim in that can be used to trim the beginning of the clip.
The maximum preroll time is 3:00 seconds.
Trigger is the time at which the switcher will start the background mix
transition, which will occur under the animation. Usually, this is the point
when the animation is full screen.
Mix specifies the duration of the mix that will occur between preview
and program under the animation. To specify a cut instead of a mix
simply set the rate to 1 frame.
Duration refers to the length of the animation. The duration should
normally match the length of the animation. It can also be used to trim
out the end of the clip.
Operating your ATEM Switcher 129 129