Program; Preview - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Color Bars
Color bar source generated internally in the switcher.
Media Player 1
This is the fill output of media player 1, and is derived from the still or clips RGB content.
Media Player 1 Key
This is the key output from media player 1, and is derived from the still or clips alpha
content. After selecting the aux you want to route to on the ATEM 2 M/E Broadcast
Panel, simply make the selection on the select bus. On the ATEM 1 M/E Broadcast
Panel, after selecting the aux you want to route to, simply hold shift and make the
selection on the select bus.
Media Player 2
This is the fill output of media player 2, and is derived from the still or clips RGB content.
Media Player 2 Key
This is the key output from media player 2, and is derived from the still or clips alpha
content. After selecting the aux you want to route to on the ATEM 2 M/E Broadcast
Panel, simply make the selection on the select bus. On the ATEM 1 M/E Broadcast
Panel, after selecting the aux you want to route to, simply hold shift and make the
selection on the select bus.

Program

This is the switcher program out, and is the same as the main program SDI output on
the switcher. After selecting the aux you want to route to on the ATEM 2 M/E Broadcast
Panel, simply hold the two shift buttons and then make the selection on the select bus.
On the ATEM 1 M/E Broadcast Panel, after selecting the aux you want to route to, simply
hold the shift button and cut/fill button and then make the selection on the select bus.

Preview

This is the preview output and shows the source selected on the preview bus, and is the
same as the preview window in the multi view. After selecting the aux you want to route
to on the ATEM 2 M/E Broadcast Panel, simply hold the two shift buttons and then make
the selection on the select bus. On the ATEM 1 M/E Broadcast Panel, after selecting the
aux you want to route to, simply hold the shift button and cut/fill button and then make
the selection on the select bus.
Clean Feed 1
This is identical to the program output, however does not include any of the downstream
keyer contents. It's useful when you want to record a master output without logos or bugs
on the downstream keyers. After selecting the aux you want to route to on the ATEM 2
M/E Broadcast Panel, simply hold the two shift buttons and then make the selection on
the select bus. On the ATEM 1 M/E Broadcast Panel, after selecting the aux you want to
route to, simply hold the shift button and cut/fill button and then make the selection on
the select bus.
Clean Feed 2
This is the same as above, however this output is taken from between the two down
stream keyers, and so includes down stream keyer 1, but not down stream keyer 2's
output. After selecting the aux you want to route to on the ATEM 2 M/E Broadcast
Panel, simply hold the two shift buttons and then make the selection on the select bus.
On the ATEM 1 M/E Broadcast Panel, after selecting the aux you want to route to, simply
hold the shift button and cut/fill button and then make the selection on the select bus.
Routing clean feeds to aux outputs allows ultimate flexibility in the use of your program
video. From the aux outputs you can record a version of your program free from any
local broadcast branding you might have applied from the down stream keyer. This
'clean' version could then be easily used for an international broadcast. This is a very
powerful feature!
Operating your ATEM Switcher 153 153