Performing A Stinger Transition; Wipe Transition Settings - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

The border source used in a wipe transition can be any source in the switcher. For example,
a thick border with the media player as its source can be used for sponsorship or branding.

Wipe Transition Settings

On ATEM 1 M/E and 2 M/E switchers, the stinger transition uses a clip from the media player to
perform a transition. The clip is normally a graphic animation that is keyed over the background.
As the animation plays, when it is full screen, a cut or mix of the background is performed under
the animation. For example, this type of transition is very popular in sports productions for
transitioning in and out of instant replays. The stinger transition takes advantage of a special
keyer that is built into the transition block, leaving all of the upstream and downstream keyers
available for compositing your output. The following section explains how to build and perform
stinger transitions.

Performing a Stinger Transition

To perform a stinger transition on the software control panel
1 Select the STING transition style button in the transition control block.
2 In the media player palette, select the media you plan to use for the transition.
3 In the transition palette, select the stinger transition type.
4 Select the media player source that has the clip you plan to use.
5 Adjust the clip duration, trigger point, mix rate, and pre roll parameters if required.
6 Perform the transition as an auto transition from the transition control block.
You cannot perform a manual stinger transition using the fader bar.
Operating your ATEM Switcher 127 127