Recording Macros Using An Atem 1 M/E Broadcast Panel - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Recording Macros using an ATEM 1 M/E Broadcast Panel

You can record and run macros using an ATEM 1 M/E Broadcast Panel independently of ATEM
Software Control. All actions on the ATEM Software Control switcher page can be performed
using your hardware panel. If you need to mix audio, arrange graphics in the media pool, or
adjust camera settings, simply access those settings using ATEM Software Control.
The buttons used to record and run macros on the ATEM 1 M/E Broadcast Panel are located in the
system control soft buttons. The names of your macro buttons are displayed in short form in the
source names display, and you can view them by pressing the show names soft button. Macro
names longer than 4 characters are shown in their entirety in the system control LED display.
Recording a macro is easy. After pressing the 'macro' soft button to enter the macro menu,
select a macro slot by pressing any of the 10 macro buttons in the select bus. Shift select if you
want a macro slot up to 20. To select macro slots above 20 use the numeric keypad. Simply
type in a number between 1 to 100 and press the cam button to confirm your selection. Another
method is by turning the knob under the system control LED display. The same methods are
used to recall and run macros during your live production.
EFFECTS
TRANS DSK COLOR
KEYS
MEDIA SUPER
AUX MACRO
PLAYER SOURCE
SETUP PTZ
KEY KEY
1 2
LUMA CHROMA
KEY KEY
MASK
MENU
The system control soft buttons on your ATEM 1 M/E Broadcast Panel lets you
record and run macros from the panel itself. Press the 'macro' button in the
system control 'home' menu to enter the macros soft button menu.
Macro buttons for the first 20 macro slots are located in the
select bus. Shift select to select a macro above slot 10, or use
the numeric keypad. Recorded macros up to 20 will display their
respective names in short form on the source names display.
Follow the steps below to create the same 'Transitions' macro demonstrated earlier using ATEM
Software Control. This time you'll create a macro in macro slot 2.
1 Press the macro soft button in the system control 'home' menu.
2 Press macro slot button 2 located above the program bus, or by using the
numeric keypad.
1 2 3
4 5 6
7 8 9
CAM 0 CLR
KEY KEY
3 4
Control Panel
Main
ON ON ON ON
Backup
Switcher
PATTRN
CUT Main
DSK 1 DSK 2
DVE
BKGD KEY 1 KEY 2 KEY 3 KEY 4
FILL TIE TIE
KEY Backup
DIP
MIX
SHIFT DSK 1 DSK 2
CUT CUT
HOME
PREV DSK 1 DSK 2
CUT AUTO FTB
TRANS AUTO AUTO
EFFECTS
TRANS DSK
KEYS
MEDIA SUPER
AUX
PLAYER SOURCE
HYPER
SETUP PTZ
DECK
CUT
BKGD
FILL
DIP
MIX
SHIFT
PREV
CUT
TRANS
COLOR
1 2
MACRO
4 5
7 8
CAM 0
ON ON ON ON
KEY 1 KEY 2 KEY 3 KEY 4
DVE
WIPE
AUTO
Using Macros 164 164
3
6
9
CLR
DSK 1
TIE
DSK 1
CUT
DSK 1
AUTO