Auxiliary Button - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

To use the menus:
1
Press the menu button to display the menus.
2 Scroll with the knob next to the LCD to navigate through the menus to the
menu you want.
3 Press the set button and you will see the menu page will be selected to use.
4 Now scroll down the list to the specific menu setting you want to change.
5 Select it by pressing the set button.
6 Now scroll through the list of options for this menu item.
7 Press set when you want to make the desired setting active.
8 Press menu a few times to go back to the main video preview screen.

Auxiliary Button

The auxiliary button marked AUX lets you select a source for the auxiliary output.
If you want to live switch the aux output of the switcher then press the AUX button to go into
aux mode. Once in aux mode you will notice that the source buttons have now changed to
white and the aux button is illuminated white also. This means that any source button you select
will send that output to the aux SDI output of the switcher. While in aux mode, you won't be
controlling the switcher anymore and you are only changing the aux output, not the program or
preview output. To go back to normal switcher operation, just press the aux button again.
Shifted sources, such as color bars and media players, will be indicated by a flashing source
button corresponding to the shifted source when your switcher is in aux mode.
You can also change aux sources in the LCD menus, or on an external ATEM hardware control
panel, or via ATEM Software Control.
Fade to Black
When you start or finish a program, you want to be able to fade to black without worrying about
leaving a logo on the screen by accident. Your ATEM switcher has a lot of powerful features and
lots of layers that you can enable for transitions. What this means is you could have a complex
setup on the switcher with many layers but you really just want a single button to start your
program. This is what the fade to black button does.
If you press the fade to black button, marked FTB on the control panel, the whole program output
of the switcher will fade to black. The button will flash to indicate to you that it's active. You can set
the duration for the fade to black transition in the LCD menu or on the software control panel.
To fade into your live production from black, simply press the FTB button again.
Using ATEM Television Studio Pro HD 117