Software Control Panel Stinger Parameters - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Stinger Transition Settings

Software control panel stinger parameters

Source
Clip Duration
Trigger Point
Mix Rate
Pre Roll
Pre Multiplied Key
Clip
Gain
Invert Key
The media player which will be used to play the clip for the animated
transition.
Clip duration refers to the length of the animation. The duration should
normally match the length of the animation. It can also be usedh to trim
out the end of the clip.
Trigger point is the time at which the switcher will start the background
mix transition, which will occur under the animation. Usually, this is the
point when the animation is full screen.
The mix rate specifies the duration of the mix that will occur between
preview and program under the animation. To specify a cut instead of a
mix simply set the rate to 1 frame.
Pre roll is a trim in that can be used to trim the beginning of the clip.
The maximum preroll time is 3:00 seconds.
Identifies the key signal of the media player clip as a pre-multiplied key.
The clip level adjusts the threshold at which the key cuts its hole into
the clip that is playing back through the media player. Decreasing the
clip level reveals more of the background. If the background video is
completely black then the clip value is too low.
The gain adjustment electronically modifies the value which allows the
softening of the edges of the key in the clip that is playing back on the
media player. Adjust the gain value until the edge softness is desirable
but the background video luminance (brightness) is not affected.
Inverts the key.
Operating your ATEM Switcher 128 128