Dve Transitions; To Perform A Dve Transition On The Software Control Panel; To Perform A Dve Transition On The Broadcast Panel - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

Atem series
Hide thumbs Also See for ATEM Production Studio 4K:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
It is important to understand that the trigger, mix and duration times are dependant on
one another. For example the trigger + mix rate cannot be larger than the overall duration.
Note also that the time displayed in the transition rate window is equal to the overall
duration + preroll.

DVE Transitions

ATEM 1 and 2 M/E switchers include a powerful digital video effects processor for DVE
transitions. A DVE transition displaces the image in various ways to transition from one picture
to another. For example, a DVE transition can be used to squeeze the current picture off screen
revealing a new video under it.

To perform a DVE transition on the software control panel

1
On the preview bus, select the video source that you want on the program output.
2
Select the DVE transition style in the transition control block.
3
Expand the transition palette and select DVE from the transition types bar.
If the DVE is being used in an upstream key, the DVE transition style button will be
unavailable for selection until the key is taken off air and off next transition. Refer to
sharing DVE resources below for more information.
4
Use the settings in the DVE palette to customise the transition.
5
Perform the transition as an auto transition or manual transition from the transition
control block.

To perform a DVE transition on the broadcast panel

1
On the preview bus, select the video source that you want on the program output.
2
On the ATEM 2 M/E Broadcast Panel, press the DVE button which illuminates yellow.
On the ATEM 1 M/E Broadcast Panel, press the SHIFT and WIPE/DVE buttons to
select the DVE transition type. The WIPE/DVE button illuminates green to indicate
the DVE transition type is selected. The system control automatically navigates to
the DVE pattern menu. To manually navigate to the DVE pattern menu press
HOME > TRANS > DVE PATTRN.
If the DVE is already being used in an upstream key, the message DVE unavailable will
be displayed and the DVE transition type will not be available for selection until the key
is taken off air and off next transition.
Refer to sharing DVE resources in this section for more information.
3
Use the system control menu buttons to select the DVE effects, graphic effects and to
enable/disable the DVE Key.
4
Use the knobs and buttons in the system control to customize the DVE transition.
You can also enter a DVE rate using the number pad followed by the set rate button.
5
If you are performing a graphic DVE/WIPE, use the select bus to select the logo fill
source. Then press the DEST SHIFT or CUT/FILL button, depending upon your model
of broadcast panel, and use the select bus to select the logo cut source.
6
Perform the transition as an auto transition or manual transition from transition control.
Operating your ATEM Switcher
130
130

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents