To Perform A Graphic Transition On The Broadcast Panel; Description Of Graphic Wipe Parameters - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

To perform a graphic transition on the broadcast panel

1
On the ATEM 2 M/E Broadcast Panel, press the DVE button which illuminates yellow.
On the ATEM 1 M/E Broadcast Panel, press the SHIFT and WIPE/DVE buttons to select
the DVE transition type. The WIPE/DVE button illuminates green to indicate the DVE
transition type is selected.
If the DVE is already being used in an upstream key, the message DVE unavailable will
be displayed and the DVE transition type will be unavailable for selection until the key
is taken off air and off preview. Refer to sharing DVE resources in the next section for
more information.
2 From the system control menu buttons, push next until you are on the DVE Graphics
menu. You can also navigate to the DVE menu by selecting TRANS > DVE PATTRN from
the home menu and repeatedly pushing 'Next' to get to the DVE Graphic page.
3 Select one of the two graphic mix buttons, depending on which way you want your
graphic to spin across the screen.
4 Select the logo fill source and logo key source for the graphic from the select bus.
5 Set the rate and any other key parameters if required.
6 Perform the transition as an auto transition or manual transition from the transition
control block.

Description of graphic wipe parameters

Rate
Normal
Reverse
FlipFlop
Fill Source
Key Source
Sharing DVE resources
The one DVE channel available in the switcher can be used to perform DVE transitions or it can
be used in an upstream keyer. When you select a DVE transition, if the DVE is used elsewhere
in the system, the DVE transition type will not be available and, on the broadcast panel, a DVE
unavailable message will be displayed. In order to use the graphic wipe transition you must free
the DVE from where it is currently used. Verify that the upstream keys currently on program or
preview are not DVE keys and do not have fly key enabled. To free DVE from the upstream
keyer, change the key type to anything other than DVE or disable fly key. The DVE will be
released and therefore available for use as a graphic wipe.
Rate specifies the length of the transition in seconds and frames.
The rate can be adjusted using the rate knob or by entering a number
on the number pad and pressing the set rate button.
The normal direction moves the graphic from left to right.
Reverse changes the direction so that it moves the graphic from
right to left.
When FlipFlop mode is toggled on, the transition changes between
normal and reverse every time the transition is executed. The 'Normal'
or 'Reverse' light indicates the direction of the next transition.
The fill signal is the graphic used to move across the top of the
transition.
The key signal is a grayscale image that defines the region in the
graphic that will be removed so that the fill signal can be correctly
stacked on top of the wipe.
Operating your ATEM Switcher 133 133