Hyperdeck Settings; Remote Settings - Blackmagicdesign ATEM Production Studio 4K Installation And Operation Manual

HyperDeck Settings

In ATEM 6.8 or newer, you can connect up to 4 Blackmagic HyperDeck Studio disk recorders
and control them using ATEM Software Control. When connecting HyperDecks, use these
settings to configure the IP Address, select the inputs your HyperDecks are connected to,
turn the auto roll feature for each deck on or off, and set their frame offset settings so they can
switch cleanly.
Status indicators appear above and below each deck so you can easily see if they are
successfully connected and if their remote buttons are active.
For detailed information on setting up Blackmagic HyperDecks with your ATEM switcher and
setting the 'HyperDeck' configuration settings, refer to the 'HyperDeck Control' section of
this manual.
HyperDeck settings

Remote Settings

If your switcher has an RS-422 port, you can select how it is used with the 'remote' checkbox.
The options are none, VISCA and GVG, where GVG sets it to use GVG100, a common legacy
interface for communicating with equipment such as linear editing suites.
Set the RS-422 remote port to none, VISCA and GVG
Using ATEM Software Control 59 59