Settings You Need To Check - Blackmagicdesign ATEM Television Studio Installation And Operation Manual

Getting Started
14
Set Video Standard
Set Video Inputs and Labels
Customize the Multi View

Settings You Need To Check!

Now you have the software control working, you need to change some settings to use your ATEM switcher.
The changes are made in the settings tab of the ATEM Software Control and the most critical settings are
listed below:
Check 1. Set the switcher video standard
ATEM defaults to 1080i59.94 when purchased, however you might want to select another video
standard if you're working in Europe or Asia. 1080i59.94, 720p59.94 and NTSC is common in the
US and Japan, while in Europe and Asia, 1080i50, 720p50, or PAL is more common.
You need to make sure all your cameras and any connected HDMI devices are also set to the
same video standard, or they won't be visible on the switcher video inputs. This means you need
to standardize on a specific video standard for all your equipment. This is generally quite easy,
as countries have standards for their HD broadcasts and all equipment sold in these countries
matches this standard or at the very least can be switched between standards. When all video
standards are matched, you should see connected devices show up in the multi view video input
windows.
Check 2. Set and label the video input settings
Different models of ATEM switchers allow some inputs to change between multiple connections
on the rear panel. For example on the ATEM 1 M/E Production switcher model, input 1 can be
switched between HDMI and analog component.
While you're setting inputs, you might also want to change the input labels. These labels appear
on the multi view and the hardware panel. There are two labels to change: a long label used in
software, and the short label that's limited to 4 digits and used in the hardware control panel.
Check 3. Customize the multi view
There are 8 input views in the multi view, and you can select from a range of external and internal
sources to display on these views. Simply click the menus to select what you want on each view. If
you don't have 8 cameras on your job, then you can even select media players, color generators,
or aux. outputs on these views. It's extremely flexible, and you can also change the multi view
layout to suit your preference.