Studio Videohub connecting to a server via USB
Studio Videohub
Network Switch
Configuring your Videohub Server Settings
If you will be using Ethernet to connect to your Videohub, refer to the "Blackmagic Videohub
Setup" section in this manual.
Videohubs without Ethernet are connected to a computer via USB and other control panels can
see the Videohub by looking for this computer. It effectively becomes a "server", that all the
other control panels on the network can connect to.
A Videohub "server" needs a static IP address and your network administrator will probably
want to configure this for you. Please follow the steps below for your respective
operating system.
USB
Ethernet
Ethernet
Computer
Connecting Videohub to a Network
8