Volume/Tone Push Button - Datalogic Magellan 8300 Product Reference Manual

Volume/Tone Push Button

NOTE
PRESS
DURATION
Momentary
(when scanner
is asleep)
Momentary
(when scanner
is awake)
Hold, then
release when
the beeper
sounds
454
The Volume/Tone Push Button also performs multiple functions
depending upon the duration of time it is pressed:
The Volume/Tone Push Button must be configured to enable standard
functions, or the features described will not apply. Reference Chapter
6, Scanner Button Options
Volume changes made using the Volume/Tone Push Button are lost
when the scanner is powered-down and are reset to the factory default
setting. If you wish to permanently change the volume, use the special
programming labels in Chapter 6, Good Read Beep Volume .
FUNCTION
Wakes scanner from
Sleep Mode
Increments volume
Increments tone
for programming details.
COMMENT
Alternatively, the scanner can be awakened
by:
- Moving an object through the scan zone.
- A weight change on the scale.
- Scanning with an attached auxiliary scan-
ner.
Press the push button momentarily to
increase speaker volume. When the loudest
volume is reached, a repeated press of the
push button cycles volume back to the low-
est setting, then volume increases on sub-
sequent press(es). Four volume levels are
available.
Press the push button for approximately 2
seconds, then release. Each time this is
done, the beeper will sound at one of three
tones. Stop when the desired tone (high,
medium or low) is sounded.
Magellan™ 8300/8400