Datalogic Magellan 8300 Product Reference Manual page 45

NOTE
NOTE
Product Reference Guide
• The scanner indicator (top-most, green LED) will be lit (dim)
steadily.
• The 7-segment display will flash the number '8'. indicating
initialization.
• If the Selftest detects a problem, the 7-segment display will
display a number code. Refer to
for a description of failure codes and problem isolation proce-
dures.
Scale calibration may be necessary to obtain a zero reading on the dis-
play on rare occasions.
4. The unit should be permitted to reach thermal equilibrium
before proceeding to the next steps. (Reference the topic
Warm-Up Time on page
cooler temperature (such as a storage area) to a warmer envi-
ronment (such as a checkstand location), a period of 60 min-
utes must be allowed to acclimate the unit to ambient
conditions. Once installed and powered up, a "power-up"
warm-up period of 15 minutes must be allowed before cali-
brating or performing weighing operations. These two warm-
up periods may run concurrently.
5. Verify that the scanner or scanner/scale passes an operational
test by observing the following:
Pass UPC/EAN bar code labels in front of the scanner's
Scanner —
windows. Since the interface cable is not yet connected to the POS
terminal, the scanner may be limited to reading only one or two
labels (see the note that follows). The scanner indicates when each
label has been successfully read by flashing the green scanner light
and emitting a good read tone (beep). Some host interface types
may "chirp" instead of beeping
When not connected to the host, the scanner may be limited to reading
only one or two labels. (This limitation is dependent upon the interface
type.) To scan multiple labels without connecting to the host, place the
unit in Scanner Diagnostic Mode by pressing the Volume/Tone Push
Button for four seconds.
Installation Overview
Chapter 4, Problem
8.) When the unit is moved from a
.
Isolation,
33