Gtin Code 128 Supplemental Label Id - Datalogic Magellan 8300 Product Reference Manual

GTIN Code 128 Supplemental Label ID

The programming feature, Label ID Control, designates whether the Label ID
is transmitted as a prefix or suffix or if Label ID is disabled.
NOTE
346
This feature specifies a GTIN label ID to be added to bar code data
when GTIN conversion is enabled and Code 128 supplemental
addon bar code labels are converted
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code, SET GTIN CODE 128 SUPPLEMENTAL LABEL
ID on page 346 below. You'll need to cover any unused bar
codes on this and the facing page to ensure the scanner reads
only the bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix that
represent the desired Label ID characters; entered as two hex
pairs. A table containing the ASCII Character Set on page 1 and
their corresponding Hex Values is available in the inside back
cover of this manual. ASCII parameters must be input by scan-
ning a pair of hexadecimal digits for each character. Thus, to
set a two-character value of AB, bar codes containing the dig-
its '4', '1', '4', and '2' must be scanned. The selectable range
for this option is any hex value from 00 to FF (for each of the
two characters).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET GTIN CODE 128 SUPPLEMENTAL LABEL ID
Magellan™ 8300/8400