Service Access
Power Installation
Grounding
20
The scanner and scanner/scale have been engineered to allow per-
formance of all routine service and maintenance (such as "zeroing"
and calibration) without removing the scanner from the checkstand.
Additionally all cable connections made at the scanner can be con-
nected and removed while the unit is sitting on the countertop. The
installer should provide service access to all remaining cable con-
nectors as well as the AC/DC Power Supply (if installed).
Plug your scanner into an electrical outlet that has been wired to
meet all applicable electrical codes, laws, and regulations and has a
common ground with the Point-of-Sale terminal
The AC/DC Power Supply should have an AC outlet with a clean
earth ground. If you are not sure how to verify the amount of elec-
trical noise (interference) on the power line, ask a qualified electri-
cian to measure the input line voltage.
Magellan™ 8300/8400