Datalogic Magellan 8300 Product Reference Manual page 113

NOTE
Product Reference Guide
It is recommended that programming sessions be limited to one fea-
ture at a time. Should you make a mistake in the programming
sequence, it can be difficult to discover where an error has been made
if several features are programmed at once. Additionally, it can be
confusing to determine which features may or may not have been suc-
cessfully set following such a session.
3. Scan the SWITCH bar code to save any new settings and exit
Programming Mode. The scanner will sound a beep and reset
upon exiting Programming Mode, and the green LED will
return to its usual state (on steady or off).
The scanner will exit Programming Mode under the following
conditions:
— the programming sequence has been completed or the
SWITCH bar code is scanned
— five minutes have passed without scanning activity. Any
data programmed during the current session will be
ignored
condition previous to initiating the exited session.
— power is disconnected. Disconnecting power during
Programming Mode, before scanning the SWITCH bar
code, will cause all new settings to be ignored. On
power-up, the scanner will return to previous settings.
4. Maintain a good record of all changes made to ensure that you
know if the original factory settings have been changed.
1. Exception: If an interface bar code had been read while in Program-
ming Mode, the scanner will operate on the default settings for the
new interface.
1
, and the scanner will reset and revert to its
Programming Overview
101