Auxiliary Port Baud Rate
NOTE
120
Specifies the baud rate of the auxillary port when operating in PIR/
CT mode.
PIR/CT is a value-added feature which may not have been activated on
your model.
To specify the Auxiliary Port Baud Rate:
1. Scan the SWITCH bar code.
2. Scan the desired baud rate from the bar codes below and on
the immediately following pages. You'll need to cover any
unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
AUXILIARY PORT BAUD RATE = 1200
AUXILIARY PORT BAUD RATE = 2400
Magellan™ 8300/8400