NOTE
168
Maximum Host-Transmitted Message Length
Specifies the maximum number of data characters allowed in mes-
sages transmitted to the host.
To set the Maximum Host-Transmitted Message Length:
1. Scan the SWITCH bar code.
2. Scan the bar code, SET MAXIMUM HOST-TRANSMITTED MES-
SAGE LENGTH on page 168 below. You'll need to cover any
unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C
that represent the desired maximum host-transmitted mes-
sage length. The selectable range is 0-249 data characters.
(Labels that are longer than this length are not read.) Pad all
single and double digit numbers with leading zeroes to yield a
three-digit entry (000-249).
If this configuration item is set to 0 (000), there is no general length
limit imposed on data being transmitted to the host.
4. The scanner will automatically exit Programming Mode when
the appropriate amount of digits have been scanned
SET MAXIMUM HOST-TRANSMITTED MESSAGE LENGTH
Magellan™ 8300/8400