Led And Beeper Indicators; If You Make A Mistake; Return To Factory Settings - Datalogic Magellan 8300 Product Reference Manual

LED and Beeper Indicators

If You Make a Mistake...

Return to Factory Settings

CAUTION
NOTE
104
The scanner provides a set of indicators that verify/announce the
various scanner functions.
If, during a programming session, you find that you are unsure of
the scanner's settings or wish to reset the scanner's configuration,
use the Return to Factory Settings label below to return the scan-
ner's configuration to the factory settings. Scanning this label will
also reset any changes made during previous programming ses-
sions.
Scan this bar code to return the scanner to the default settings con-
figured at the factory for the currently active interface. This bar
code is typically used to return the scanner to a "known" operating
state when the present programming status is not known, faulty, or
suspect.
Use this bar code with caution, since it will reset ALL features that
may have been programmed since the scanner's installation.
DO NOT scan the SWITCH bar code before and after scanning this bar
code, as the bar code below automatically enters and exits Program-
ming Mode as a part of its function. If this bar code is scanned follow-
ing a SWITCH bar code, it will simply cause the scanner to exit
Programming Mode without making changes.
RETURN TO FACTORY SETTINGS
Magellan™ 8300/8400