Beep After Weigh - Datalogic Magellan 8300 Product Reference Manual

Hide thumbs Also See for Magellan 8300:

Table of Contents

RS-232 Beep After Weigh

Enables/disables the ability of the scanner to beep after weight data

is transmitted to the host. Scale interfaces that support this item

are: RS-232 ICL, RS-232 SASI, and RS-232 Single Cable.

To enable/disable the Beep After Weigh feature:

1. Scan the SWITCH bar code.

2. Scan either the enable or disable bar code below. You'll need

to cover any unused bar codes on this and the facing page to

ensure that the scanner reads only the bar code you intend to

3. Complete the programming sequence by scanning the SWITCH

BEEP AFTER WEIGH = DISABLE

BEEP AFTER WEIGH = ENABLE

Magellan™ 8300/8400

Magellan 8400